What Makes UltraSMR Different?
11 points by bluedino 3 days ago | 9 comments

ejiblabahaba 44 minutes ago
As a relatively unserious data hoarder with a ZFS NAS, SMR drives are unusable, and are famous for resilver times ranging from weeks to never (drive times out). I'm sure there are workloads where they make sense (maybe archiving huge binary blobs). A while back Dropbox was using mostly SMR drives, so maybe the firmware and software ecosystem available for enterprise use cases is more approachable than I thought. And with the AI-driven price explosion for storage, perhaps the total cost of ownership even with the software investment starts to make sense.
reply
undersuit 21 minutes ago
SMR drives are the worst, even had issue resilvering a 2TB mirror.

What's frustrating is even just a little info from the manufactures would be beneficial, like the size of a shingle so the computer could batch writes, or even if the drive is shingled!

reply
accrual 14 minutes ago
I read a nice write-up of Dropbox's use of SMR drives here:

https://dropbox.tech/infrastructure/four-years-of-smr-storag...

reply
creatonez 2 hours ago
I could only find an explanation of what it actually is here: https://documents.westerndigital.com/content/dam/doc-library...
reply
shadowpho 2 hours ago
Thanks. Looks like SMR drives will get a bit more dense, but with the same limitations as before — no update in place without bunch of rewriting.

Means they are still bad in RAID setups

reply
dcan 2 hours ago
Host-Managed SMR is a good middle-ground, but the file system support is still poor.
reply
londons_explore 57 minutes ago
I think the future of hard drives involves absolutely huge error correction block sizes - 1 gigabyte or more.

The way it would work is:

* The underlying disk would do sequential writes only, in 1Gb blocks, rather like a log filesystem.

* The large block size enables much better information density due to being able to tolerate far more errors.

* Random reads within blocks can usually be done - but occasionally most or all of the whole block will need to be read to decode the data.

* A small capacitor+disk momentum ensures any writes that happened before a power failure can always be completed - either to the real disk or to flash.

* The OS still only sees 4k pages - versioning, packing those into 1Gb blocks, mappings and garbage collection are all handled inside the drive.

reply
kvemkon 39 minutes ago
> any writes that happened before a power failure can always be completed

It can be also the data milliseconds after loosing power. The minimal amount of data in question is the data that the drive has acknowledged to the OS after a special command.

Anyway, this problem is already solved at least few years ago.

reply
formerly_proven 23 minutes ago
Has Western Digital found yet another way to further degrade the performance of their drives beyond their initial deployment of OptiNAND and SMR? At this rate the tail latency of a tape robot is going to outperform WD spinning rust.
reply